Feb 23, 2010 The Debut III is a complete 'plug'n'play' record player that includes a Pro-Ject 8.6 tonearm and an Ortofon OM 5E moving-magnet cartridge. The cartridge comes already installed and aligned; all you need do is install the counterweight, set the tracking and antiskating forces, unlock the motor transport screw, and you're ready to go. Pro-Ject Essential III Turntable with Built in Phono Preamplifier - Black. $389.00 $ 389. Get it as soon as Thu, Oct 24. FREE Shipping by Amazon. Pro-Ject Debut Recordmaster Walnut Turntable with USB and Phono Preamp. 5.0 out of 5 stars 3. $499.00 $ 499. Get it as soon as Thu, Oct 24.
The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before
connecting the power supply to the mains.
Switching on and off
Pressing the power switch (20) alternately starts or stops the motor.
Cartridge downforce adjustment
The counterweight (6) supplied is suitable for cartridges weighing between 3,5 - 5,5g. Alternative counterweights for cartridges weighing between 6 - 9g or 1,5 - 3g are available as accessory parts.
Downforce adjustment must be completed with the anti-skating weight and the drive belt removed, and the motor running. Pushing carefully, turn the counterweight (6) onto the rear end of the tonearm tube (9), and so that the downforce scale (6a) shows towards the front of the player. the armlift and position the cartridge in the space between arm rest and platter. Carefully rotate the counterweight (6) until the armtube balances out. The arm
should return to the balanced position if it is moved up or down. This adjustment must be done carefully. Do not forget to remove the cartridge protection cap if fitted. Once the arm is correctly balanced return it to the rest. Hold the counterweight (6) without moving it, and gently revolve the downforce scale ring (6a) until the zero is in line with the anti-skating prong (15). Check whether the arm still balances out. Rotate the counterweight counter clockwise (seen from the front) to adjust the downforce according to the cartridge manufacturer's recommendations. One mark on the scale represents 1 mN (= 0,1g / 0,1 Pond) of downforce.
Dash cam manual. Whilst adjusting the downforce the drive belt must be removed and the motor must be switched on,
otherwise the arm lift cannot be lowered. The recommended downforce for the factory fitted cartridge is 17,5mN.
Fitting the drive belt and the platter
Fit the drive belt (3) around the hub (4) and the smaller diameter part of the motor pulley (2). Avoid getting sweat or grease on the belt as these will deteriorate the performance and reduce the belt's lifespan. Use absorbent kitchen paper to remove any oil or grease from the outer edge of the hub and the belt. Fit the platter (5) and felt mat over the spindle of the hub (4).
Anti-skating force adjustment
The anti-skating force must be adjusted according to the mass of the cartridge as follows: Downforce
Slip the loop of the anti-skating weight's thread over the third groove of the stub to set the correct anti-skating force for the factory-fitted cartridge. Feed the thread through the loop of the wire support (17).